How to Install a T & K Wall Bracket

Tools needed

• A ladder
• SDS cordless drill
• Short 8mm, 16mm drill bits
• Ratchet with 13 & 17 mm long neck sockets
• Snips
• Safety equipment (harness, safety mat etc)

Equipment needed

• T&K wall bracket set - (choice of 12, 18 or 24 sets with 18 being most popular)
• Pole (1.8m long, 32mm diameter - steel or aluminium)
• Shield anchor bolt M10 (qty: 5)
• U-bolts - small or large will do (qty:2)

Location

• On a gable wall of a house to ensure aerial is above roof line of neighbouring buildings if possible

Steps to Install

• Position ladder to left (if right handed) of where  brackets are to be mounted.  
• Secure the ladders and put on all safety equipment 
• Ascend the ladder with the drill, tools, bolt and T-bracket 
• After selecting desired location use 8mm bit to drill guide holes 
• Now use 16mm bit to drill hole 
• Use ratchet and 17mm socket to bolt on T bracket using the shield anchor bolts (qty:) 
• Repeat steps 4-5 to place position K bracket approximately 35cm below the T  bracket 
• Insert the U-bolts into the bracket and loosely tighten 
• THE TK WALL BRACKET INSTALLATION IS NOW COMPLETE !